How To Reset The Xumo Remote To Factory Settings

Do you need to reset your Xumo remote to factory settings?

If your Xumo remote is not working correctly, experiencing connectivity issues, or responding slowly, performing a factory reset may help.

Resetting your remote can restore it to its original settings, removing any previous pairings or configurations.

If you don’t know what a factory reset does, it erases all stored settings on your remote and restores it to the default state it had when it was first used.

This can help resolve issues related to unresponsive buttons, failed pairings, or syncing problems with your Xumo device.

In this guide, you will learn how to reset your Xumo remote to factory settings and what to do if the reset does not work.

When Should You Reset Your Xumo Remote?

A factory reset is useful in several situations, including:

• The remote is not responding to button presses.
• The remote is not pairing with the Xumo Stream Box or TV.
• Voice commands are not working correctly.
• The remote keeps disconnecting or losing signal.
• You are switching the remote to a different device.
• The remote settings have been changed, and you want to restore them.

If you are facing any of these issues, resetting the Xumo remote might help restore functionality.

How to Reset the Xumo Remote to Factory Settings

Follow these steps to reset your Xumo remote:

1. Remove the Batteries

Open the battery compartment at the back of the remote and take out the batteries.

2. Press and Hold the Power Button

While the batteries are out, press and hold the Power button for about 10-15 seconds.

This will discharge any remaining power in the remote.

3. Reinsert the Batteries

Place the batteries back into the remote and close the battery cover.

4. Perform the Reset Combination

Depending on your Xumo remote model, you may need to press a specific button combination to complete the reset.

Try holding down the Home and Back buttons at the same time for about 10-15 seconds until the remote’s light blinks.

5. Pair the Remote Again

If your Xumo remote connects via Bluetooth, you will need to re-pair it with the Xumo Stream Box:

Go to Settings on your Xumo device.

Select Remotes & Devices > Pair New Remote.

Follow the on-screen instructions to complete the pairing process.

What If the Reset Does Not Work?

If your Xumo remote is still not working after the reset, try these troubleshooting steps:

• Replace the Batteries – If your batteries are weak or drained, the remote may not function properly even after a reset.
• Check for Obstructions – If you are using an infrared (IR) remote, make sure there are no obstacles between the remote and the Xumo device.
• Update Your Xumo Device – If the remote is not pairing, updating the Xumo Stream Box firmware might help.
• Try a Different Remote – If possible, test another remote to determine whether the issue is with the Xumo device or the remote itself.
• Contact Xumo Support – If none of these steps work, visit Xumo’s Support Page for additional help or to request a replacement remote.

Conclusion

Resetting your Xumo remote to factory settings is a simple but effective way to fix connectivity and response issues.

By following the steps outlined in this guide, you can restore your remote to its default settings and re-pair it with your Xumo Stream Box.

If the reset does not resolve the problem, consider checking the batteries, updating your device, or reaching out to Xumo support for further assistance.

Additional Reading:

How To Use Xumo Remote Spectrum

How To Pair/Program Xumo Remote To Xumo Box

How To Factory Reset Xumo Box Without Remote